APPLICATION

1. Locate the space on the wall where the image will be applied.

2. Make sure it is clean and dust-free.

3. Remove the backing paper and expose the adhesive.

4. If you tack the sheet to itself, just pull it apart.

5. Tack it to the wall and apply light pressure from the middle, outward to the edges.

   Use a soft cloth or your hand to apply the graphic.

6. Make sure the complete sheet and all the edge shave been applied.

Multiple Panels

1. Locate the space on the wall where the image will be applied.

2. Make sure it is clean and dust-free. The software automatically adds appropriate

   overlaps when your print has multiple panels.

3. Start with the largest piece and position on the wall. You can even mark the wall

   if you want to be exact.

4. Remove the backing paper and expose the adhesive. If you should touch the sheet

   to itself, just pull it apart.

5. Tack it to the wall and apply light pressure from the middle, outward to the edges.

   Use a soft cloth or your hand to apply the graphic.

6. Make sure the complete sheet and all the edges have been applied.

7. Continue with the next piece and match the sheets with the overlap (approximately .25 inch) to build the image.

8. From this overlap, apply pressure outward to ensure a perfect match. Do this with all the sheets until they are completed.

9. If the graphic is in the correct spot, go over the complete image while also making sure that all overlaps have been matched up precisely.

Then carefully lift the complete image and reposition it. If you have problems with this technique, just reapply piece by piece until it is all together again.

You can move your image over and over again. Remember to save the backing paper in case you want to store the image or trade it.

HAVE FUN!